238
Integrator Mode
16) FRONT INDICATOR Setting
This function controls the flashing of the indicator on the front of the display.
Factory setting: ON
1 Enter the integrator mode.
(Refer to section 5.4.1, “About the Integrator Mode” (pg. 214).)
2 Select ‘OPTION’.
3 Place the cursor on ‘FRONT INDICATOR’ then press the
[SET] button to change the setting.
Each time the [SET] button is pressed, the setting changes
as shown below.
ON: Normal LED function
OFF: Lights red during standby
The ‘FRONT INDICATOR’ setting is common for all inputs.
Note
Regardless of the ON/OFF setting, during POWER MANAGEMENT operation and shutdown, the green indicator
flashes.
Screen 3
INTEGRATOR INPUT1
CHANGE
SCREEN SETUP OPTION
FAN CONTROL
OSD
FRONT I ND I CATOR
COLOR MODE
PRO USE
FRC
PICTURE
:
:
:
:
SET
EXIT
MENU
AUTO
NORMAL
ON
ON
3
ON
OFF 2
To Next Page
Loading...
