Voltage selector
You can find the voltage selector switch on the rear
panel of multi-voltage models.
The factory setting for the voltage selector is
220 - 230 V. Please set it to the correct voltage for
your country or region.
Before changing the voltage, disconnect the AC power
cord. Use a medium size screwdriver to change the
voltage selector switch.
Medium size
screwdriver
D3-4-2-1-5_En
Changing the TV format setting
If the HOME MENU is not displayed correctly, it may be
that the TV system is set incorrectly for your country or
region.
1 With the receiver in standby, press STANDBY/
ON while holding down the HOME MENU button.
2 Select PAL/NTSC using /, then select PAL or
NTSC using /.
The display shows the new setting (PAL or NTSC).
Changing the frequency step
If you find that you cannot tune into stations
successfully, the frequency step may not be suitable for
your country/region. Heres how to switch the setting:
1 With the receiver in standby, press STANDBY/
ON while holding down the HOME MENU button.
2 Select FREQ.STEP using /, then select 9k or
10k using /.
The display shows the new setting:
9k
10k
220 - 230 V
240 V
VOLTAGE
SELECTOR
For Australia Model
VENTILATION CAUTION
When installing this unit, make sure to leave space
around the unit for ventilation to improve heat
radiation (at least 60 cm at top, 10 cm at rear, and
30 cm at each side).
WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the
product, and to protect it from overheating. To
prevent fire hazard, the openings should never be
blocked or covered with items (such as newspapers,
table-cloths, curtains) or by operating the
equipment on thick carpet or a bed.
D3-4-2-1-7b_A_En
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which
requires repair will be charged for even during the
warranty period.
K041_En
If the AC plug of this unit does not match the AC
outlet you want to use, the plug must be removed
and appropriate one fitted. Replacement and
mounting of an AC plug on the power supply cord of
this unit should be performed only by qualified
service personnel. If connected to an AC outlet, the
cut-off plug can cause severe electrical shock. Make
sure it is properly disposed of after removal.
The equipment should be disconnected by removing
the mains plug from the wall socket when left
unused for a long period of time (for example, when
on vacation).
D3-4-2-2-1a_A_En
STANDBY/ON
INPUT
SELECTOR
PHASE
CONTROL
ADVANCED
MCACC
DIGITAL
VIDEO
SCALER
HDMI
MASTER
VOLUME
To Next Page
Loading...
Need help?
General
