Controlling the rest of your system
14
99
En
Chapter 14:
Controlling the rest of your system
Setting the remote to control other
components
Most components can be assigned to one of the input
source buttons (such as DVD or CD) using the
component’s manufacturer preset code stored in the
remote.
However, there are cases where only certain functions
may be controllable after assigning the proper preset
code, or the codes for the manufacturer in the remote
control will not work for the model that you are using.
If you can’t find a preset code that matches the
component you want to control, you can still teach the
remote individual commands from another remote
control (see Programming signals from other remote
controls below).
Note
• You can cancel or exit any of the steps by pressing
M
ULT
I OPERATION. To go back a step, press
RETURN.
•After one minute of inactivity, the remote
automatically exits the operation.
Selecting preset codes directly
1 While pressing
MULTI OPERATION
, press
HOME
MENU
.
The remote LCD display shows SETUP.
2Use
/
to select
PRESET
, then press
ENTER
.
3 Press the input source button for the component
you want to control, then press
ENTER
.
When assigning preset codes to TV CONTROL, set the
operation selector switch to TV here.
The LCD on the remote displays the component you want
to control (for example DVD or TV).
1
4Use
/
to select the first letter of the brand name
of your component, then press
ENTER
.
This should be the manufacturer’s name (for example, P
for Pioneer).
5Use
/
to select the manufacturer’s name from
the list, then press
ENTER
.
6Use
/
to select the proper code from the list,
then try using this remote with your component.
The code should start with the component type (for
example, DVD 020). If there is more than one, start with
the first one.
2
To try out the remote control, switch the component on or
off (into standby) by pressing SOURCE. If it doesn’t
seem to work, select the next code from the list (if there
is one).
• If you can’t find or properly enter a preset code, you
can still teach the remote individual commands from
another remote control (see Programming signals
from other remote controls below).
7 If your component is controlled successfully, press
ENTER
to confirm.
The remote LCD display shows OK.
DVD
RECEIVER SOURCE
MAIN
MULTI
OPERATION
ZONE2 3
VIDEO1
GALLERY
HOME MEDIA
CD
HDMI
TUNER
PHONO
VIDEO2 VIDEO3
DVR2
BD TV DVR1
CD-R
INPUT SELECT
DVD
MULTI
OPERATION
VIDEO1
GALLERY
HOME MEDIA
CD
HDMI
TUNER
PHONO
VIDEO2 VIDEO3
TV
BD DVR1 DVR2
CD-R
MAIN
ZONE2 3
AUDI O
PARAMETER
TOP MENU
BAND
iPod CTRL
EXIT
TOOLS
STATUS PHASE CTRL CH LEVEL
MENU
T.EDIT
VIDEO
PARAMETER
SOURCE
TV RCV
INPUT MUTE MUTE
VOL
VOL
TV CONTROL
CH
ENTER
RETURN
PTY
SEARCH
TUNE +
TUNE
ST ST +
ENTER
HOME
MENU
1 You can’t assign TUNER or HOME MEDIA GALLERY.
2 • When using a Pioneer HDD recorder, please select PIONEER DVR 487, 488, 489 or 493.
• When using a Pioneer flat screen TV released prior to summer 2005, please select preset codes 637 or 660.
SCLX81_71.book 99 ページ ２００８年７月２５日 金曜日 午後３時１分
To Next Page
Loading...
Need help?
General
