Using the tuner
06
42
En
1 Tune to a station you want to memorize.
See Listening to the radio on page 41 for more on this.
2 Press
T.EDIT
(
TUNER EDIT
).
The display shows STATION MEMORY, then a blinking
memory class.
3 Press
CLASS
to select one of the three classes, then
press
ST +/–
(
/
) to select the station preset you
want.
You can also use the number buttons to select a station
preset.
4 Press
ENTER
.
After pressing ENTER, the preset class and number stop
blinking and the receiver stores the station.
Naming station presets
For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press
T.EDIT
(
TUNER EDIT
).
The display shows STATION NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
four characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
!”#$%&’()
∗+,–./:;<=>?@[ \ ]^_{|} ˜ [space]
Use / to select a character, / to set the position,
and ENTER to confirm your selection.
Tip
•To erase a station name, simply repeat steps 1 to 3
and input four spaces instead of a name.
• Once you have named a station preset, you can press
DISP when listening to a station to switch the display
between name and frequency.
Listening to station presets
You will need to have some presets stored to do this. See
Saving station presets above if you haven’t done this
already.
1 Press
TUNER
to select the tuner.
2 Press
CLASS
to select the class in which the station
is stored.
Press repeatedly to cycle through classes A, B and C.
3 Press
ST +/–
(
/
) to select the station preset you
want.
• You can also use the number buttons on the remote
control to recall the station preset.
SCLX81_71.book 42 ページ ２００８年７月２５日 金曜日 午後３時１分
To Next Page
Loading...
Need help?
General
