Piper Cherokee Six - Page 138

PIPER
CHEROKEE
SIX SERVICE
MANUAL
by priming,
again
sanding
and applying
color coat.
NOTE
Brush
and hands
may
be cleaned
in solvents
such
as acetone
or methylethylketone.
If solvents
are
not available,
a strong
solution
of detergent
and
water may
be used.
4-23. SAFETY
WALK
REPAIR.
4-24.
SURFACE
PREPARATION.
a.
Clean
all surfaces
with a
suitable
cleaning
solvent
to remove
dirt, grease
and
oils.
Solvents
may be
applied by
dipping, spraying
or mopping.
b.
Insure
that no
moisture
remains
on
the surface
by
wiping
with
a clean
dry cloth.
c. Outline
the area
to which
the
liquid safety
walk
compound
is to
be applied,
and
mask
adjacent
surfaces.
NOTE
Newly
painted
surfaces,
shall be
allowed
to dry for
2.5 hours
minimum
prior to
the application
of the
safety walk.
4-25.
PRODUCT
LISTING
FOR
LIQUID
SAFETY
WALK
COMPOUND.
a.
Suggested
Solvents:
Safety
Solvent
per
MIL-S-18718
Sherwin
Williams
Lacquer
Thinner R7KC
120.
Glidden
Thinner
No.
207
b.
Safety Walk
Material:
Walkway
Compound
and matting
nonslip
(included
in
Piper Part
No.
179872.)
4-26.
APPLICATION
OF
LIQUID
SAFETY
WALK
COMPOUND.
Liquid
safety
walk
compound
shall
be applied
in
an area,
free of
moisture
for
a period
of 24
hours minimum
after application.
Do not
apply
when
surface
to
be coated
is
below
50
°
F. Apply
liquid
safety
walk compound
as follows:
a. Mix
and
thin
the liquid
safety
walk
compound
in
accordance
with
the
manufacturer's
instructions
on the
container.
b.
Coat the
specified
surfaces
with
a smooth,
unbroken
film
of the
liquid safety
walk
compound.
A nap
type
roller
or a
stiff
bristle
brush
is recommended,
using
fore and
aft
strokes.
c. Allow
the
coating
to dry
for 15
minutes
to one
hour
before recoating
or touch-up;
if
required
after
application
of the
initial
coating.
d.
After
recoating
or touch-up,
if done,
allow
the coating
to
dry for
15 minutes
to
one
hour
before
removing
masking.
NOTE
The
coated
surface
shall
not be
walked
on for six
hours
minimum
after
application
of final
coating.
Added: 7/29/77 STRUCTURE
1F18