Piper Cherokee Six - Methods of Securing Trim Cables

PIPER CHEROKEE
SIX SERVICE
MANUAL
124
Figure 5-7. Methods
of Securing
Trim Cables
tunnel.
e.
The trim control
cables (8 and
9) may be removed
by the following
proce-
dure:
1. Remove the center
seats, and the pilot and rear
seats if desired.
2. Remove the
seat belts attached
to the forward
floor tunnel
by removing
attachment
nuts,
washers and bolts.
3. Remove the
heater deflectors from each side
of the aft end of the for-
ward floor
tunnel by sliding
the deflector sideways
and releasing
the retainer
spring.
4. Unfasten
the carpet from
the aft portion
of the forward
floor tunnel and
lay it forward.
5. Remove the
tunnel cover located
between the
trim control
wheel and the
spar cover by removing attachment screws.
6. Remove
the cable pulleys
(6) located
in the forward
tunnel by removing
the cotter pin, washer and clevis pin (5).
7. Remove
the floor panel aft of the main
spar by removing the panel
at-
tachment screws and seat
belt attachments. Lift the panel
and remove from air-
plane.
8. Remove the cable
rub blocks (39) located in the floor
opening on the aft
side of the main spar by removing the block attachment screws.
9. Remove the trim plate located
on top of the forward end
of the aft floor
tunnel.
10. Remove the carpet from the aft floor tunnel.
11. Remove the cover plate from the top of the aft floor tunnel by removing
attachment screws.
SURFACE
CONTROLS
Issued:
8/17/72
1H11