Pixsys ATR 142 User Manual

User manual - ATR142- 47
50
d G t.i .
Digital Input
Digital input functioning. (parameter 7.11)
Parameter 48 selection must be
co nt.
or
Pr. cy .
di s .
Disabled > Default
st.st.
Start/Stop
rn.n.o.
Run n.o.
rn.n.c.
Run n.c.
L.c.n.o.
Lock Conversion n.o. (Lock visualisation on
display with N.O. contact)
L.c.n.c.
Lock Conversion n.c. (Lock visualisation on
display with N.C. contact)
tune
Tune > Manual
a.ma.i.
Automatic Manual impulse
a.ma.c.
Automatic Manual Contact
t.1.s.s.
Timer 1 Start Stop
51
Gra d.
Gradient
Rising gradient for soft start or pre-programmed cycle
0 Disabled > Default: 0.
1-9999 Digit/time
7
(degrees/hours with display of tenths
if temperature)
52
m a . ti .
Maintenance Time
maintenance time for pre-programmed cycle
00.00-24.00 hh.mm > Default: 00.00
7
The display of decimal point depends on the setting of parameter
sen.
and the parameter
d.p.

Pixsys ATR 142 Specifications

General

Brand	Pixsys
Model	ATR 142
Category	Controller
Language	English