32
no. Display Parameter description Entering range
31
Alarm 2
Alarm 2 selection.
Alarm intervention is
associated with AL2
(Disabled) Default
(Absolute Alarm)
(Band Alarm)
(High Deviation Alarm)
(Low Deviation Alarm)
(Absolute Command setpoint Alarm)
(Start Alarm)
(Cooling)
32
Alarm 2 State
Output
Alarm 2 output contact
and intervention type
(n.o. start) Default
Normally open, active at start
(n.c. start)
Normally closed, active at start
(n.o. threshold)
Normally open, active on reaching
alarm
5
(n.c. threshold)
Normally closed, active on reaching
alarm
5
33
Alarm 2
Reset
Type of Reset for contact
of alarm 2
(Automatic Reset)
Default
(Manual Reset)
(Manual Reset Stored)
34
Alarm 2 State
Error
State of contact for alarm
2 output in case of error
Default
35
Alarm 2 Led
State of OUT2 led
corresponding to relative
contact
Default
36
Alarm 2
Hysteresis
Alarm 2 hysteresis
-999…+999 digit
∗
(tenths of degree if temperature).
Default: 0.
5
On activation, the output is inhibited if the controller is in alarm mode. It activates
only if alarm condition reappears after that it was restored.
To Next Page
Loading...
