Pixsys ATR142 - Page 36

36
no. Display Parameter description Entering range
48
Operating
Mode
Select operating mode
(Controller) Default
(Programmed Cycle)
(2 Thresholds Switch)
(2 Thresholds Switch
Impulsive)
(3 Thresholds Switch
Impulsive)
(4 Thresholds Switch
Impulsive)
49
Automatic /
Manual
Enable automatic/manual
selection
(Disabled) Default
(Enabled)
(Enabled Stored)
50
Digital Input
Digital input functioning
(P48 selection must be
or )
(Disabled) Default: 0.
(Start/Stop)
(Run n.o.)
(Run n.c.)
(Lock Conversion n.o.)
(Lock Conversion n.c.)
(Tune) Manual
(Automatic Manual
impulse)
(Automatic Manual
Contact)
51
Gradient
Increase gradient for soft
start or pre-programmed
cycle
0 disabled
1-9999 Digit/time
∗
(degrees/hours with display of tenths
if temperature)
Default: 0.
∗
The display of the decimal point depends on the setting of parameter
and parameter .