Pixsys ATR620 - Page 33

84
1
8, O, 1
2
8, E, 1
3
8, N, 2
4
8, O, 2
5
8, E, 2
3
rd
Digit – Enable Modbus delay
0
Delay desabled.
1
Delay enabled (15, 12, 9, 6, 3 ms ).
4
th
Digit – Enable software upgrade via serial input
0
software upgrade via serial input desabled
1
software upgrade via serial input enabled
P-50
Slave address (0/99, 0 forMaster function).
Select Modbus address of Slave. Enter 0 for Master.
(see 32.2 ).
P-51
Data visualization on display
Select visualization for second display and which data can be
visualized pressing .
1
st
Digit – Visualization on second display
0
Process 2
(ex. temperature of second thermocouple)
1
Setpoint programmed for step end
(ex.temperature expected at end of running step)
2
Control Setpoint
(updated according to programmed gradient)
3
Number of cycle in execution
4
Time elapsed after cycle START (hours:minutes)
5
Number of step in execution
2
nd
Digit – Visualization of data during the cycle pressing
“Scroll” key
Chronometer
(hours:minutes)
% output
(0…100%)
Step number
(1…20 max)
0
No No No
1
Yes No No
2
No Yes No
3
Yes Yes No
4
No No Yes
5
Yes No Yes
6
No Yes Yes