Pixsys ATR620 - Configuration Table

100
38 Configuration table
Date: Model ATR620:
Installer: Plant:
Notes:
P-01
General configuration
P-02
Analog input AN1
P-03
Analog input AN2
P-04
Reserved
P-05
Control output and source of setpoint
P-06
Lower limit setpoint 1 (-999/3000 digit)
P-07
Upper limit setpoint 1 (-999/3000 digit)
P-08
Lower limit range AN2 for V/mA(-999/3000digit)
P-09
Lower limit range AN2 for V/mA (-999/3000digit)
P-10
Alarms hysteresis (-999/3000)
P-11
Configuration alarm no.1 (OUT)
P-12
Configuration alarm no.2 (A1)
P-13
Configuration alarm no.3 (A2)
P-14
Setpoint alarm no.1(-999/3000 digit)
P-15
Setpoint alarm no.2(-999/3000 digit)
P-16
Setpoint alarm no.3(-999/3000 digit)
P-17
Configuration digital input IN1
P-18
Configuration digital input IN2
P-19
Configuration Autotuning,step visualization
P-20
Power heating elements (0.0/999.9 KWatt)
P-21
Waiting for step end (1/1440 min)
P-22
Max gap at step end (1/200 digit)
P-23
Cycle recovery
P-24
Reserved
P-25
Filter analog inputs (1/20 medie)
P-26
Offset calibration AN1 (-15.0/15.0 digit)
P-27
Gain calibration AN1(-10.0%…+10.0%)
P-28
End ON/OFF control (-999/3000digit)
P-29
Reserved