Pixsys ATR620 - Page 50

101
P-30
Max. time for impulse zone 1 (1/120sec)
P-31
Limit of control signal zone 1 (10/100%)
P-32
Reserved
P-33
Reserved
P-34
Reserved
P-35
ON/OFF hysteresis;PID dead band (-99.9/300.0digit)
P-36
Proportional band (0-3000digit)
P-37
Integral time (0/9999 sec).
P-38
Derivative time (0.0/999.9 sec).
P-39
Lower limit scale 3 (-999/3000 digit)
P-40
Upper limit scale 3 (-999/3000 digit)
P-41
Offset AN2 (-15.0/15.0 digit)
P-42
Gain AN2(-10.0%…+10.0%)
P-43
Max. time for impulse zone 2 (1/120sec)
P-44
Limit of control signal zone 2 (10/100%)
P-45
ON/OFF hysteresis;PID dead band (-99.9/300.0digit)
P-46
Proportional band (0-3000digit)
P-47
Integral time (0/9999 sec).
P-48
Derivative time (0.0/999.9 sec).
P-49
Configuration serial input
P-50
Slave address (1/99).
P-51
Visualization in RUN/START mode
P-52
Programming block, endless step