33 Error messages
In case that the plant does not
work properly, the controller stops
the eventual cycle in progress and shows an error message for the
Example: a damaged thermocouple will be noticed with error code
flashing on display1. For details see table below.
# Cause Do
E-01
Programming error E
²
PROM. Contact technical support
E-03
Wrong cycle data Program a new cycle
E-04
Wrong configuration data
probable lost of calibration
values
Verificare che i parametri di
configurazione siano corretti.
E-05
Disconnected thermocouple or
temperature out of range
Check sensors connection,
eventually contact technical
support
E-07
Wrong recovery data. Recovery
function not available
Confirm and start a new cycle
E-11
Cold junction failure or ambient
temperature out of range
Contact technical support
To Next Page
Loading...
