PLANET ECLIPSE GEO CS1 - Page 23

FIG-1
FIG-3
FIG-2
FIG-4
23
GEO:CS1
FIG-1 - FIRE MODE PARAMETER
Select and edit the ring mode of the CS1 outside
of the pre-set modes.
> SEMI: Default mode. 1 shot per trigger pull.
> RAMP: See ramp setup (page 24).
> CANCEL: Editing is cancelled and unchanged.
FIG-2 - ROF CAP PARAMETER
This implements a cap to the maximum rate of re
the CS1 will achieve.
> ON: ROF limited to the BS ON ROF value.
> OFF: ROF limited to loader speed.
> CANCEL: Editing is cancelled and unchanged.
FIG-3 - BS ON ROF PARAMETER
Limits the maximum rate of re the CS1 will
achieve with the breech sensor (BS) On.
This will only be displayed if the ROF CAP is On.
> Range: 4.0 - 30.0 bps (balls per second)
In 0.1 increments.
1
1 Always calibrate your ROF CAP parameters to the local eld
meter for consistency.
FIG-4 - BS OFF ROF PARAMETER
Limits the maximum rate of re the CS1 will
achieve with the breech sensor (BS) disabled.
This should be set to the loader’s slowest speed.
> Range: 4.0 - 15.0 bps (balls per second)
In 0.1 increments.
1
1 Always calibrate your ROF CAP parameters to the local eld
meter for consistency.
ELECTRONICS
USER INTERFACE PARAMETERS