User’s Manual of IMG-110T
-15-
2.1.5 Hardware DIP Switch for Reset to Default
The upper panel of the Industrial Modbus Gateway consists one 4-bit DIP switch for resetting the system to the factory default
mode.
■ Resetting to default through hardware DIP switch:
1: Find the hardware DIP switch that is near the RJ45 port of the Industrial Modbus Gateway.
2: Adjust DIP 2 at the “ON” position and DIPs 1, 3, 4 remain at the original position.
3: After adjusting the DIP switch, please power off and power on the Industrial Modbus Gateway to take effect.
After resetting the Industrial Modbus Gateway with the default IP address, and username and
password: admin, please adjust
DIP 2 to lower position. Otherwise, the Industrial Modbus Gateway will
continue to reset to the factory default mode.
To Next Page
Loading...
Need help?
General
