User’s Manual of IMG-110T
-67-
6. COMMAND LINE MODE
The CLI groups all the commands in appropriate modes according to the nature of the command. A sample of the CLI
command modes are described below. Each of the command modes supports specific software commands.
After logging in and accessing the Industrial Modbus Gateway Telnet interface, please enter “?” or “help” under Industrial
Modbus Gateway Telnet interface where it displays a list of the available commands and descriptions of the commands. The
telnet commands list screen appears as Figure 5-3 shows.
Figure 6-1: Telnet Help Screen of Industrial Modbus Gateway
The page includes the following configurable data:
List
List command name under Telnet interface.
Help
List command name and help information under Telnet interface.
Quit
This command will log out Telnet interface.
Exit
This command will exit the current mode and back to the initial mode.
Reboot
This command will reboot the Industrial Modbus Gateway.
Serial
This command will access serial setup menu.
Security
This command will access security setup menu.
To Next Page
Loading...
Need help?
General
