Planmeca ProOne - Introduction to Planmeca ProOne X-ray Unit

1 INTRODUCTION
Installation Manual Planmeca ProOne 3
1 INTRODUCTION
This manual contains the information required to install the Planmeca ProOne X-ray unit.
Please read this manual carefully before installing the X-ray unit.
NOTE
Required software versions:
• Planmeca ProOne software version 1.9.0.0.r or later
• Planmeca Romexis software version 4.4.1.r or later
• Didapi software version 5.5.0.r or later
2 ASSOCIATED DOCUMENTATION
The X-ray unit is supplied with the following manuals:
• User’s Manual, Original English publication: 10016256
• Installation Quick Guide, Original English publication: 10040577
• Installation Manual, Original English publication: 10016257
• Technical Manual, Original English publication: 10016258
• Planmeca Device Tool Manual, Original English publication: 10031558
These manuals are intended to be used in conjunction with the documentation for the
Planmeca Romexis program. The program package contains the following manuals:
• User’s Manual, Original English publication: 10014593
• Technical Manual, Original English publication: 10037884
NOTE
The User’s Manuals are available on Planmeca’s website.
• For X-ray units, select Material bank > Manuals > Imaging
• For software products, select Material bank > Manuals > Software
The other manuals are available on Planmeca’s Dealer Support website. This website
requires a password.