TABLE OF CONTENTS
ii Planmeca ProX
User’s Manual
Planmeca pursues a policy of continual product development. Although every
effort is made to produce up-to-date product documentation this publication
should not be regarded as an infallible guide to current specifications. We reserve
the right to make changes without prior notice.
COPYRIGHT PLANMECA
Publication number 10029963 Revision 3
Released 03 December 2012
The manufacturer, assembler and importer are responsible for the safety, reliability
and performance of the unit only if:
- installation, calibration, modification and repairs are carried out by qualified and
authorized personnel
- electrical installations are carried out according to the appropriate requirements
such as IEC 60364
- equipment is used according to the operating instructions.
16 PROGRAMMING EXPOSURE VALUES .......................................................36
16.1 Programming default exposure values ........................................................................ 36
16.2 Programming the density values .................................................................................. 37
16.3 Programming the preprogrammed settings ................................................................. 38
17 EXPOSURE VALUE TABLES .......................................................................40
17.1 Exposure values for Planmeca ProSensor and Planmeca Dixi2 V3 sensors .............. 40
17.2 Exposure values for Dixi2 V1 sensors (high sensitivity) .............................................. 42
17.3 Exposure values for speed F films ............................................................................... 44
18 ERROR CODES .............................................................................................46
19 CLEANING .....................................................................................................47
19.1 Surfaces ....................................................................................................................... 47
19.2 Film holder ................................................................................................................... 47
20 SERVICE ........................................................................................................47
21 DISPOSAL OF THE UNIT ..............................................................................48
22 TECHNICAL SPECIFICATIONS ....................................................................49
22.1 Technical data .............................................................................................................. 49
22.2 Dimensions (in mm) ..................................................................................................... 51
22.3 Planmeca ProX minimum dimensions ......................................................................... 52
22.4 Installation options ....................................................................................................... 54
22.5 User’s statement for Planmeca Prox ........................................................................... 55
To Next Page
Loading...
Need help?
General
