Planmeca ProX 1
INTRODUCTION
User’s Manual
1 INTRODUCTION
The Planmeca ProX X-ray unit produces intraoral X-ray
images for the diagnosis of teeth and adjacent structures.
The unit is allowed to be used only under supervision of a
dental/health care professional.
This manual describes how to operate the Planmeca ProX
intraoral X-ray unit equipped with Planmeca Dixi or
Planmeca ProSensor digital X-ray system. Please read
these instructions carefully before using the unit.
Note that if you use the Planmeca Dixi or Planmeca
ProSensor digital X-ray system, you need a PC with a
Planmeca Romexis/Dimaxis imaging software to save,
view and modify the radiographs. The Planmeca Romexis/
Dimaxis software has a separate manual, which should be
used in conjunction with this manual.
CAUTION FOR US USERS:
Federal law restricts this device to sale by or
on the order of a health care professional.
NOTE This manual is valid for software revisions 4.00 or
later.
NOTE The Planmeca ProX intraoral X-ray unit is allowed to
be used only under supervision of a dental/health
care professional.
The Planmeca ProX intraoral X-ray unit fulfils the
requirements of Directive 93/42/EEC.
All key illustrations indicate that the key should be pressed
or, where indicated, pressed and held down. Pressing a
key will either switch a function on or off, depending on the
original setting, or change the indicated value.
The display values shown in this guide are only examples
and should not be interpreted as recommended values
unless otherwise stated.
Make sure that you are fully acquainted with the
appropriate radiation protection measures and these
instructions before using the unit.
To Next Page
Loading...
Need help?
General
