Planmeca ProX User Manual

Planmeca ProX 39
PROGRAMMING EXPOSURE VALUES
User’s Manual
Press the SELECT key again briefly, the mA display will
start to flash and the kV value is stored in the memory.
The mA value can now be changed with the parameter
adjustment keys.
You can now select a new exposure region or exit the
programming mode by pressing and holding down the
SELECT key (about 4 seconds). You will hear a signal
tone.
NOTE If you interrupt programming for over 45 seconds, the
unit automatically exits the programming mode, and
the current values will be stored in the memory.
6

Planmeca ProX Specifications

General

Type	Intraoral X-ray
Tube current	7 mA
Imaging Technology	Digital
Focal spot	0.4 mm
X-ray generator	High-frequency
Power Requirements	100–240 V AC, 50/60 Hz
Tube voltage	60-70 kV