PMA KS 98 - Page 93

Inputs/outputs
Digital inputs
store
dynamic
This input reacts only on a positive flank, i.e. on a change from 0 to 1. With this flank, input values
x1...x4 are stored in the recipe block selected with SetNo. The values are stored in RAM and in
EEPROM.
+
With store = 0 or permanent 1, storage is omitted.
manual
manual = 0: automatic mode: recipe function active
manual = 1: manual mode: the values of inputs x1...x4 are applied to y1...y4 directly.
Analog inputs
x1...x4
In mode STORE (store =1), the values applied to
x1
...
x4
are written into the memory locations of
the group selected with SetNo.
The inputs are connected with the outputs directly in manual mode (manual = 1) and also when
the SetNo input is beyond range 1...5.
SetNo5
Selecting a recipe block:
The value of SetNodetermines, which one of the 5 recipe blocks is selected. Selection is valid
for reading and storage (r store). A recipe block is selected only with a value within 1...5 at
SetNo. With SetNo out of range 1...5, the inputs are connected directly with the outputs
(independent of the status at the A/M input manual). This is required for cascading.
Analog outputs
y1...y4
The values at y(i) correspond either to the recipe block selected with SetNo or to inputs x(i) in
manual mode (store =1).
Casc
The value at output Casc is the value of input SetNo reduced by 5 and is used for
cascading.
Parameters:
Via interface, 20 parameters (5 recipe blocks each with 4 values) can be preset:
Parameter Description Range Default
Set1.1
Recipe block 1
Parameter 1 for recipe 1
-29 999...999 999 0
Set1.2
Parameter 2 for recipe 1
-29 999...999 999 0
Set1.3
Parameter 3 for recipe 1
-29 999...999 999 0
Set1.4
Parameter 4 for recipe 1
-29 999...999 999 0
Set2.1
Recipe block 2
Parameter 1 for recipe 2
-29 999...999 999 0
Set2.2
Parameter 2 for recipe 2
-29 999...999 999 0
Set2.31
Parameter 3 for recipe 2
-29 999...999 999 0
Set2.4
Parameter 4 for recipe 2
-29 999...999 999 0
Set3.1
Recipe block 3
Parameter 1 for recipe 3
-29 999...999 999 0
Set3.2
Parameter 2 for recipe 3
-29 999...999 999 0
Set3.3
Parameter 3 for recipe 3
-29 999...999 999 0
Set3.4
Parameter 4 for recipe 3
-29 999...999 999 0
Set4.1
Recipe block 4
Parameter 1 for recipe 4
-29 999...999 999 0
Set4.2
Parameter 2 for recipe 4
-29 999...999 999 0
Set4.3
Parameter 3 for recipe 4
-29 999...999 999 0
Set4.4
Parameter 4 for recipe 4
-29 999...999 999 0
9499 040 50611 Selecting and storage
93 REZEPT ( recipe management )