Pneumercator TMS3000 - Event Conditions

OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 28
Event log reports may contain any combination of the following data:
EVENT CONDITIONS
Errors: Codes:
System
Boot Prom Checksum (U4 socket) 01
Flash Prom Checksum (U5 socket) 02
Flash Prom Write (U5 socket) 03
Flash Prom Erase (U5 socket) 04
Serial Prom (CM1) 05
Probe
Probe Sync 10
Probe Timeout 11
Fault detecting sensors
Sensor Short Circuit 20
Sensor Open Circuit 21
Sensor Wiring Fault 22
Warnings: Codes:
Modem Initialization 01
Modem Command 02
Modem Timeout 03
Modem Carrier 04
Modem Communication 05
Modem No dial tone 06
Tank Configuration Checksum 07
Probe Configuration Checksum 08
Header Configuration Checksum 09
Relay Tank Configuration Checksum 10
Relay CC Configuration Checksum 11
Relay Sensor Configuration Checksum 12
Relay Status Configuration Checksum 14
CC Configuration Checksum 15
Sensor Configuration Checksum 16
Inventory Configuration Checksum 17
Theft Configuration Checksum 18
Modem Configuration Checksum 19
Dial out Configuration Checksum 20
Power Failure 21
Information Messages: Codes:
Change of SP Units 01
Low Product, Ungaugeable Level 02
*For detailed definitions of TMS Events, Warnings, and Information Messages, see Appendix A.