OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 66
2.4.3.16 SYSTEM CONFIGURATION – TANK LEAK
Config
Header Header – General System Settings
tank Tank – Tank Channel specific including geometry and SetPoints
Probe Probe – Level Gauging Probe settings
ReLy tank Relay Tank – Relay Assignments to Tank Channel Specific conditions
ReLy cc Relay CC – Relay Assignments to individual Non-Hazardous CC Inputs
ReLy Sens Relay Sensor – Relay Assignments to individual Leak/Point Level Sensor Inputs
ReLy LLP Relay LLP – Relay Assignments to external LS300 Line Leak failures
ReLy Site Relay Site – Relay Assignments to Site-Specific conditions
ReLy Mode Relay Mode – Relay-specific behavior settings
cc input Non-Hazardous Contact Closure (CC) Inputs
Sensr inp Leak/Point Level Sensor Inputs
Inventory Shift Inventory Report Schedule
tHeft Theft – Detection (Hours of operation)
Modem Modem/Serial C Communications
diaL out Auto-Dial out - Setup for selected Alarms or Tank information
tank LEAk In-Tank Leak Test – Setup
AnaLogout Analog Outputs
tAnk LEAk In-Tank Leak Test – Setup: The configuration of the In-Tank Leak Test is defined in this submenu
in conjunction with scheduling/time related settings in the Leak Test menu. The Group ID references
the Tank Channel being configured.
Prerequisites for running a valid In-Tank Leak Test are as follows (Refer to the National Workgroup website,
www.nwglde.org, or contact Pneumercator for up-to-date information):
• Tank requirements
o Single-Wall Underground Storage Tank
o Isolated (Not Manifolded)
o Not Heated or Pressurized
o Up to 75,000 Gallon [283,900 Liter] capacity
▪ 0.2 GPH [0.8 LPH] in 2 hours for tanks up to 20,000 Gallons [75,700 Liters]
▪ 0.1 GPH [0.8 LPH] in 8 hours for tanks up to 20,000 Gallons [75,700 Liters]
▪ 0.2 GPH [0.8 LPH] in 8 hours for tanks up to 75,000 Gallons [283,900 Liters]
• Qualifying Petroleum Product as defined by the Federal EPA.
• MP450S
o Riser Mounted
o 4-inch Urethane or Buna-N floats
o 5 Temperature Sensors
After enabling a test, the following front panel display characteristics may appear while in View Mode.
• When the Mode button is pressed and released, the TMS will normally display the Tank Name. In
addition, if an In-Tank Leak Test is scheduled, a short letter L (/) will appear on the far-left directly above
Tank ID number.
• The TMS will show a blinking short letter L (/) to the right of the Tank ID number if the In-Tank Leak Test
is Paused.
• When an In-Tank Leak Test is actively running, a short letter L (/) will appear to the right of the Tank ID
number.
test En In-Tank Leak Test Enable: Enable the In-Tank Leak Test for the specified Tank Channel.
Entry Type: select list
Range Limits: No, Yes
Default/Initialized value: no
To Next Page
Loading...
