OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 73
3.3 AUTOWINDER PRINTER (900438-2)
PRINTERPAPER REPLACEMENT (WITH WINDER)
1. Lift the used paper roll from the rack and remove the roll from the shaft.
2. Insert the shaft into the new paper roll and return it to the rack.
3. Remove the knob and swing open the printer assembl y.
4. Feed the paper into the printer mechanism and press the paper feed button
until paper feeds through to the outside of the printer assembl y.
5. Bend the end of the paper over 1/4" and route the paper as shown belo w.
6. Insert the paper into the winder and wind the paper in 2 or 3 times.
REPLACEMEN T PAPER ROLL P/N 183601-1
VIEW INSIDE COVER
PRINTER ASSY.
SIDE VIEW
STANDING
ON HINGE
RACK
PAPER SHAFT
PAPER ROLL
PAPER
PRINTER
MECHANISM
PAPER
FEED
BUTTON
PAPER
OUTSIDE
PRINTER
ASSEMBLY
PRESS HERE
TO REPLACE
RIBBON
RACK
P
APER
P
APER
P
APER
FEED
KNOB
FEED
WINDER
PAPER SHAFT
PAPER ROLL
PAPER
PRINTER
MECHANISM
RIBBON
To Next Page
Loading...
