Pneumercator TMS3000 - Appendix A: Alarm & Event Conditions; Alarm Conditions

OPERATION & MAINTENANCE MANUAL TMS2000/3000 TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 74
APPENDIX A – TMS CONSOLE AL ARM & EVENT COND ITIONS TABLES
Alarm Conditions:
The following alarm condi tions are recorded in the
Alarm Log
and are printed automatically if printer is enabled. Alarm conditions are also user
programmable to auto-dial out upon alarm .
Leak and Setpoin t alarms will produce both audible and visual LED annunciators until ackn owledged via Front panel or Edit enable butto ns. Visua l LED
conditions will continue until the specific le ak or setpoint co
nditions are corrected.
Theft alarms will produce an audible annunciator and appear on the TMS display showing a theft message condition across the display. Theft alarms can
only be ackn owledged via t he Edit enabl e button. The displayed mes sage will conti nue until the c onditio n is cor rected.
CC and ISCC alarms will produce an audible annunciator and appear on the TMS display showing a CC or ISCC alarm message across the display. The
audible annu nciator can be ackn owledge d via Front panel or Edit enable buttons. The CC or ISCC displayed message will continue until the condi tion is
correc ted.
A
larm Des cription
Display and
Printout Onl y
Displa y, Printout, and Co mpute r Format
Status Detail Description Item ID Nam e Notes
Leak n/a IN-TANK LEAK A LARM tank # n/a Failure of an In-Tank Le ak Test
SP1 n/a PRO DUCT SETPOINT #1 ALARM tank # SP1 Nam e
Meets or exceeds the programmed produc t SetPoint.
Factory default value is for a HIGH HIGH alarm at or
above 95% of Gross Volum e.
SP2 n/a PRODUCT SETPOIN T #2 ALARM tank # SP2 Nam e
Meets or exceeds the programmed produc t SetPoint.
Factory default value is for a HIGH alarm at or abov e
90% of Gross Volume .
SP3 n/a PRO DUCT SETPOINT #3 ALARM tank # SP3 Nam e
Meets or exceeds the programmed produc t SetPoint.
Factory default value is for a LOW alarm at or below
20% of Gross Volume .
Water n/a WATER SE TPOINT A LARM tank # n/a
Meets or exceeds the programmed water SetPoint.
Factory default value is 2 inches [51 millimeters] or
higher of bottom water in ta nk.
Theft n/a THEFT ALARM tank # n/a Theft of produc t from the tank
CC Open
CONTACT CLOSU RE ALARM -
OPE N
cc #
Contact Clos ure
Name
Device wired to CC Input is in alarm
CC Close d
CONTACT CLOSU RE ALARM -
CLOSE D
cc #
Contact Clos ure
Name
Senso r Open POINT SENSOR A LARM - OPEN sensor # Sensor Nam e
Point level (High, L ow, etc.) sensor is in alarm
Senso r Close d POINT SENSOR A LARM - CLOSED sensor # Sensor Nam e
Senso r Open LEAK SENS OR ALARM - OPEN sensor # Sensor Nam e
Non-discrimi nating leak se nsor is in alarm
Senso r Close d LEAK SENS OR ALARM - CLOSED sensor # Sensor Nam e
Senso r Produc t LEAK SENSOR ALARM - PROD UCT sensor # Sensor Nam e
Discriminatin g leak sensor i s in alarm
Senso r Water LEAK SENSOR ALARM - WATER sensor # Sensor Nam e
Note: IS CC or Intrinsically Safe Contact C losure is syno nymous with Leak/Pt. Level Sensor