Pneumercator TMS3000 - Error Conditions

OPERATION & MAINTENANCE MANUAL TMS2000/3000 TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 75
Error Conditions:
All Error conditions are recorded in the Event Log and are printed automatically if printer is enabl ed. Error condi tions are also user programmable to auto-
dial out upon alarm. Errors will produce an audible alarm and appear on the TMS display showing the specific error condition and code number. Errors
conditions can only be silen ced by ackn owledging the Front pane l or Edit enable buttons. The displayed error message will continue until the condi tion is
correc ted.
Event Descr iption for Error s
Error # Description Item ID Nam e Note s
1 BOOT PROM CHECKSUM
ERR OR
n/a n/a Trouble with boot prom firmware chip in U4 socke t
2 FLASH PROM CHECKSUM
ERR OR
n/a n/a
Trouble with flash prom firmware chip in U5 socket
3 FLASH PROM WRI TE ERROR n/a n/a
4 FLASH PROM ER ASE ERROR n/a n/a
5 EEPROM CHECKSUM ERROR n/a n/a Trouble with CM1 chip in U2 (TMS3000) or U14 (TMS20 00) socket
10 PROBE SYNC ERROR probe # n/a Unintelligi ble signal being r eceived from probe
11 PROBE TIMEOUT ERROR probe # n/a No signal bei ng detected fro m probe
20 SENS OR FAULT - SHOR T
CIRCUI T
sensor # sensor name
Wiring fault with all sensors except ES825-200F
21 SENS OR FAULT - OPEN
CIRCUI T
sensor # sensor name
22 SENS OR FAULT sensor # sensor name Wiring fault with ES825-2 00F
Note: IS CC or Intrinsically Safe Contact C losure is syno nymous with Leak/Pt. Level Sensor