OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 61
2.4.3.13 SYSTEM CONFIGURATION – THEFT
Config
Header Header – General System Settings
tank Tank – Tank Channel specific including geometry and SetPoints
Probe Probe – Level Gauging Probe settings
ReLy tank Relay Tank – Relay Assignments to Tank Channel Specific conditions
ReLy cc Relay CC – Relay Assignments to individual Non-Hazardous CC Inputs
ReLy Sens Relay Sensor – Relay Assignments to individual Leak/Point Level Sensor Inputs
ReLy LLP Relay LLP – Relay Assignments to external LS300 Line Leak failures
ReLy Site Relay Site – Relay Assignments to Site-Specific conditions
ReLy Mode Relay Mode – Relay-specific behavior settings
cc input Non-Hazardous Contact Closure (CC) Inputs
Sensr inp Leak/Point Level Sensor Inputs
Inventory Shift Inventory Report Schedule
tHeft Theft – Detection (Hours of operation)
Modem Modem/Serial C Communications
diaL out Auto-Dial out - Setup for selected Alarms or Tank information
tank LEAk In-Tank Leak Test – Setup
AnaLogout Analog Outputs
tHeft Theft – Detection (Hours of operation): Defines the Site Hours of Operation. Any loss of Product
during the hours the facility is Closed is defined as a Theft. Individual Tank Channels may have
Theft monitoring enabled with the Theft enable setting in the Tanks submenu within the
Configuration menu.
M-F OPEN Weekdays (Monday – Friday) Hours of Operation: Define the hours the facility opens and
M-F CLOSE closes during the week.
Entry Type: 4 digit numeric hours, minutes
Range Limits: 00’00 – 23’59. (24-hour clock format)
Default/Initialized value: 00’00
Example 12’00 = 12 Noon 23’59 = 11:59 PM 00’00 = Midnight
Sat OPEN Saturday Hours of Operation: Define the hours the facility opens and closes on Saturday.
Sat CLOSE Entry Type: 4 digit numeric hours, minutes
Range Limits: 00’00 – 23’59. (24-hour clock format)
Default/Initialized value: 00’00
Example 12’00 = 12 Noon 23’59 = 11:59 PM 00’00 = Midnight
Note: Set the Open and Close times to match if the facility is closed on Saturday.
Sun OPEN Sunday Hours of Operation: Define the hours the facility opens and closes on Sunday.
Sun CLOSE Entry Type: 4 digit numeric hours, minutes
Range Limits: 00’00 – 23’59. (24-hour clock format)
Default/Initialized value: 00’00
Example 12’00 = 12 Noon 23’59 = 11:59 PM 00’00 = Midnight
Note: Set the Open and Close times to match if the facility is closed on Sunday.
Return Return: Press EDIT (TEST) to exit Theft submenu.
Note: Press STEP (MODE) to return to top of Theft submenu showing M-F OPEN
(Monday-Friday Open)
To Next Page
Loading...
