OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 34
2.4.3.1 SYSTEM CONFIGURATION – HEADER
ConFig
Header Header – General System Settings
tank Tank – Tank Channel specific including geometry and SetPoints
Probe Probe – Level Gauging Probe settings
ReLy tank Relay Tank – Relay Assignments to Tank Channel Specific conditions
ReLy cc Relay CC – Relay Assignments to individual Non-Hazardous CC Inputs
ReLy Sens Relay Sensor – Relay Assignments to individual Leak/Point Level Sensor Inputs
ReLy LLP Relay LLP – Relay Assignments to external LS300 Line Leak failures
ReLy Site Relay Site – Relay Assignments to Site-Specific conditions
ReLy Mode Relay Mode – Relay-specific behavior settings
cc input Non-Hazardous Contact Closure (CC) Inputs
Sensr inp Leak/Point Level Sensor Inputs
Inventory Shift Inventory Report Schedule
tHeft Theft – Detection (Hours of operation)
Modem Modem/Serial C Communications
diaL out Auto-Dial out - Setup for selected Alarms or Tank information
tank LEAk In-Tank Leak Test – Setup
AnaLogout Analog Outputs
Header Header: A collection of General Use and Global Settings for the TMS. It is recommended that these
settings are configured prior to configuring other TMS features to ensure the TMS is configured
properly and completely.
Acc Code Access Code: A six-digit numeric value used in conjunction with the Communications Security
feature to restrict Serial, Network, and Modem communication to the TMS. See Appendix C for
configuring TMS DIP switches to enable security feature.
Entry Type: 6-digit numeric
Range Limits: 000000-999999
Default/Initialized value 000000
SeCurity Security: specifies the communications interfaces where the security feature is enforced. See
Appendix C for configuring TMS DIP switches to enable security feature.
Entry Type: select list
Range Limits: Serial: Affects all serial and network interfaces
Modem: Affects all modem interfaces
Both: Affects all communications interfaces including serial, network, and
modem.
Default/Initialized value SeriaL
Unit id Unit ID: serves several purposes as follows:
• Printed on all reports created on TMS printer
• Required with Site ID for firmware upgrades to prevent unauthorized changes
• Identifies TMS with Site ID when Dialing Out to computer with Autopolling application
Entry Type: 2-digit numeric
Range Limits: 00-99
Default/Initialized value: 00
Site id Site ID: serves several purposes as follows:
• Printed on all reports created on TMS printer
• Required with Unit ID for firmware upgrades to prevent unauthorized changes
• Identifies TMS with Unit ID when Dialing Out to computer with Autopolling application
Entry Type: 5-digit numeric
Range Limits: 00000-99999
Default/Initialized value: 00000
To Next Page
Loading...
