Pneumercator TMS3000 - Page 65

OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 65
Dialout Conditions: The TMS will attempt to contact the Receiving Device defined in Line Type
above for any of the conditions selected below:
LEAk diaL Failed In-Tank Leak Test
SP1 diaL Product SetPoint 1 Alarm (3 Product SetPoint Firmware Only: Vxx99xx or Vxx00xx).
SP2 diaL Product SetPoint 2 Alarm (3 Product SetPoint Firmware Only: Vxx99xx or Vxx00xx).
SP3 diaL Product SetPoint 3 Alarm (3 Product SetPoint Firmware Only: Vxx99xx or Vxx00xx).
CritHdiaL Critical High Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
HiHi diaL High High Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
High diaL High Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
Lo diaL Low Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
LoLo diaL Low Low Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
CritLdiaL Critical Low Product Alarm (6 Product SetPoint Firmware Only: Vxx01xx).
h2o diaL Bottom Water SetPoint Alarm
thft diaL Theft Alarm
cc diaL Non-Hazardous Contact Closure (CC) Input Alarm
sens diaL Sensor (ISCC) Alarm
Err diaL System Error
Entry Type: Select List
Range Limits: No, Yes
Default/Initialized value: no
Inv diaL Inventory Dialout: Enables the TMS to initiate a dialout contact at the time scheduled below
when there are new Inventory Logs created since the last Inventory Dialout.
Entry Type: Select List
Range Limits: No, Yes
Default/Initialized value: no
Inv Hour Inventory Dialout Time: Defines the time at which the Scheduled Inventory Dialout occurs. This
context sensitive menu is only visible if the Inventory Dialout is set to YES.
Range Limits: 00’00 – 23’59. (24-hour clock format)
Default/Initialized value: 00’00
Example 12’00 = 12 Noon 23’59 = 11:59 PM 00’00 = Midnight
Return Return: Press EDIT (TEST) to exit Dial Out submenu.
Note: Press STEP (MODE) to return to top of Dial Out submenu showing teL LOCAL
(Tel Local)