OPERATION & MAINTENANCE MANUAL TMS2000/3000
TMS Operations and Maintenance Manual.docx February 12, 2018
PAGE 68
rLy CntrL Relay Control: Defines the Relay Outputs used to isolate a tank from a manifolded set to support
a Scheduled In-Tank Leak Test. The Relay Outputs change state at the defined start time of
the test The actual test begins fifteen minutes afterward. The Relay Outputs return to their
defined Normal Contact State when the test is no longer running. This context-sensitive menu
is only visible when the Test Mode is set to RELAY (Timed Relay).
Entry Type: numeric list
Range Limits: Each Relay: No (No Relay Assignment), 1-32 (TMS3000), 1-18 (TMS2000)
Note: Each assignment separated by decimal point.
Default/Initialized value: no.no.no
Return Return: Press EDIT (TEST) to exit Tank Leak submenu.
Note: Press STEP (MODE) to return to top of Tank Leak submenu showing test En
(Test Enable)
To Next Page
Loading...
