OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 44
2.9.3 LEAK TEST SCHEDULING - AUTO
Auto Leak Test Mode has the leak test being started by the TMS based on the site activity monitored
through a CC Input. The Scheduling window shown above shows a Warning Date – No Monthly Test
feature. When configured, the TMS will provide a warning when the tank has not satisfied its monthly
test requirements. It is recommended to set this value so there would be enough time to manually
shut down the tank and perform a leak test.
If the test requires a minimum % Volume, be sure to check the box to establish that requirement. The
test will NOT run if the percent volume is below this threshold. The percentage value is configured in
the Setup/Config/Tanks/Leak Test menu (See Section 2.8).
To Next Page
Loading...