OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 67
2.17 ANALOG OUTPUTS
Touch the +/- buttons to increment Analog Output Channel by 1. Touch the Analog Output Channel
to bring up a list of possible Analog Output Channels. Touch the Analog Output Channel on the table
to make a selection.
Each desired output must be assigned to a Tank Channel to enable the output. The Data Parameter
specifies the information represented by the Analog Output Channel. The Gain should be left
configured as 1.00 unless 0-1 mA mode is required. In that case, the Analog Output Card should be
configured for 0-20 mA. Consult Bulletin 139 for complete details.
To Next Page
Loading...