OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 60
2.13 INVENTORY
When enabled, the TMS will record inventory snapshots/shift reports to the Inventory Log, as
scheduled.
The snapshot can be enabled for any or all of the seven days of the week be checking the appropriate
checkboxes. The snapshot is disabled by unchecking all days of the week.
Inventory Log Times: Up to three snapshots can be made daily by setting three different times above.
If only one or two snapshots daily are required, make sure that there are only that many different
times listed above. For example, if all three Log Times were configured for midnight, one snapshot at
midnight would occur if there were any days of the week checked. By changing one of the three times
to 12:00PM, you would record two snapshots daily: one at midnight and one at noon. This assumes
that at least one day of the week is checked.
Each snapshot can generate a printout on the TMS if desired by checking the appropriate box.
To Next Page
Loading...