OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 25
2.5 TANKS - DIMENSIONS
The TMS support a wide range of tank shapes and sizes. These supported tanks can be configured
by selecting the basic tank shape from the list as described below:
Flat: Flat-ended horizontal cylinder.
Vertical: includes vertical cylinders and rectangular tanks. Any tank with a constant volume per unit
of level is supported with this type
Custom (3): A horizontal cylinder with curved or dished ends.
Custom (8): An asymmetrical tank or other tank with unusual geometry. Contact Pneumercator for
assistance.
Vertical Conical: A vertical cylinder with a cone bottom.
Virtual: Combines multiple tank to for a virtual tank for the purpose of defining Product Set Points for
the collective volume.
To Next Page
Loading...