OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 19
1.8 TOUCH SCREEN CALIBRATION
Note: Only applies to First Generation Resistive LCD Screens ONLY
The ability to recalibrate the touch screen is available in the event the user’s touch does not match
where the system responds to the touch. It is NOT recommended to perform this without contacting
Pneumercator Technical Support. Note that you will need a stylus to properly recalibrate the screen.
Failure to follow these instructions may result in the screen being unresponsive and require parts be
returned to Pneumercator as directed by Pneumercator Technical Support.
Touching the Touch Cal button will show the above notification screen.
Follow the onscreen instructions above to complete the calibration. The calibration MUST BE
COMPLETED to exit this screen.
To Next Page
Loading...