EasyManua.ls Logo

Pneumercator TMS4000 - Dial Out

Pneumercator TMS4000
94 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 62
2.15 DIAL OUT
Touch the +/- buttons to increment Dial Out Configuration Number by 1. Touch the Dial Out
Configuration Number to bring up a list of possible Dial Out Configuration Numbers. Touch the Dial
Out Configuration Number on the table to make a selection.
Phone Number: supports a total of 21 digits to make a phone call. A comma represents a pause. See
Pause Length in Section 2.16, Modem section for details on setting the length from 1-9 seconds.
Receiving Devi: choice of the following Receiving Devices:
Data (PC): a computer with TMS Communicator installed and Autopolling running and set to
answer the phone upon ringing. The Autopolling configuration controls what data is requested.
Fax: Any device capable of receiving a fax via phone. Transmits a generic fax report showing
inventory with probe and sensor alarm statuses.
TTY: A text only transmission that can be received by any TTY capable device. HyperTerminal
or other terminal emulation program is capable of handling this signal. Transmits a printout
comparable to the printout generated by the TMS on its integrated printer.
Numeric pager: Any numeric pager. Alphanumeric pagers are not supported. Message is
limited to what can be incorporated into the 21 digit dial out string
Conditions that will initiate an outbound phone call are as follows:
Product Set Point: Any Product Set Point for any tank channel
Water Set Point: Any Water Set Point for any tank channel
Temperature Set Point: Any Temperature Set Point for any tank channel
Contact Closure In: Any active CC Input. CC Inputs are found on select relay I/O cards.
Leak/Point Sensors: Any Sensor alarm.
Error: Any system error recorded in the Events log
Theft: Any documented theft recorded in the Thefts Log
Leak: Any Failed In-Tank Leak Test. Not to be confused with Leak Sensors.
Inventory: A daily dialout at the time listed below the checkbox if new Inventory Report exists.