OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 50
2.12 RELAYS
Relay outputs may be configured to trigger from any system alarm or event. The conditions are
divided into several categories for easy selection. Any one condition may be assigned to up to three
relays. The last category, Relay Mode, contains settings that affect the behavior of the relay.
2.12.1 RELAYS – TANK TRIGGERS
Touch the +/- buttons to increment Tank Channel by 1. Touch the Tank Channel number to bring up
a list of possible Tank Channels. Touch the Tank Channel number on the table to make a selection.
Relay assignments for both the Product Set Points and the failure of an In-Tank Leak Test (Leak).
To Next Page
Loading...