OPERATION MANUAL TMS4000
TMS4000 Operation Manual 2018-08-03.docx August 3, 2018
PAGE 8
1.3 ALARM ACKNOWLEDGMENT
Clicking on the Alarm Acknowledgment button (shown with a Bell icon) in the top left corner of the
Main screen will silence the integrated horn and present the screen shown below. This provides the
means of viewing the current Alarm/Event status and contains four different buttons on the left edge
for acknowledging different categories of Alarm/Event conditions. The conditions that may be
acknowledged in each button are listed below the screenshot.
General Acknowledgment: Represented by a bell icon without supporting text. The list of common
conditions that may be acknowledged include:
• Tank Product Set Points
• Tank Water Set Points
• Tank Temperature Set Points
• Leak/Point Level Sensor Alarms
• CC Inputs
Leak Acknowledgment: The bell icon shown with LEAK below it is used to acknowledge a Failed
In-Tank Leak Test. Once acknowledged, the failure will be removed from the list and will no longer
cause the Alarm LED to be lit.
Theft Acknowledgment: The bell icon shown with THEFT below it is used to acknowledge a theft of
product from a tank. Theft is an optional feature that must be enabled through the system
configuration. Details are provided in a later section.
System Acknowledgment: The bell icon shown with SYSTEM below it is used to acknowledge
system Events. These include Probe Timeout, Probe Sync, and Sensor Fault Errors.
To Next Page
Loading...