8
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
8.35
8. Place shock shaft in clamp blocks and insert needle
into shock shaft.
9. Thread in the damping jet and torque to specification.
TORQUE
Damping Jet: 40 lb-in (4.5 Nm)
10.Reverse shock shaft in clamp blocks and apply a thin
layer of Slick Honey to metering rod.
ASSEMBLY CONTINUED
1. Apply specified Loctite® two threads down and two
threads wide completely around shock shaft threads.
2. Place shaft back in clamp blocks, apply Loctite®
primer to eyelet, and Torque eyelet to shock shaft to
specification.
TORQUE
Eyelet: 30 lb-ft (41 Nm)
3. Reverse shock shaft in clamp blocks and install air
side shaft spacers (if equipped) and jounce bumper.
STEERING / SUSPENSION
To Next Page
Loading...
