Polaris GENERAL 2019 - Page 399

8
9929375 R02 - 2016-2019 GENERAL / GENERAL 4 Service Manual
© Copyright Polaris Industries Inc.
8.39
21.Install Bottom Out Cup into the body cap prior to
installing body (if equipped).
22.Apply Loctite® 638 to body two threads down and two
threads wide completely around body.
23.Place body in clamp blocks and install body cap.
Torque body cap to specification using body cap
socket.
TORQUE
Body Cap: 100 lb-ft (136 Nm)
24.Place body in block clamps parallel to the ground.
25.Replace both O-rings on DSC or LSC. Torque DSC or
LSC to specification.
TORQUE
DSC: 35 lb-ft (47 Nm)
LSC: 12 lb-ft (16 Nm)
26.Apply Loctite® to LSC screw (if equipped).
27.Install LSC knob and torque screw to specification.
TORQUE
LSC Knob: 14 lb-in (1.6 Nm)
STEERING / SUSPENSION