To Next Page

To Previous Page

8.8

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

REAR BEARING REPLACEMENT

Bearing Removal

1. Remove the outer snap ring

2. Press bearing out using a hydraulic press and

appropriately sized adapter.

3. Inspect the bearing carrier housing for scratches,

wear or damage. Replace rear bearing carrier if

damaged.

Bearing Installation

4. Thoroughly clean the rear bearing carrier housing

and the outer race on the new bearing. Be sure that

all oil and Loctite residue has been removed from

each surface.

5. Support the bottom of the bearing carrier housing.

CAUTION

Use an arbor and press only on the outer race,

otherwise bearing damage may occur.

6. Apply Loctite

603

™

to the circumference of the new

bearing race

7. Carefully press the new bearing into the bearing

carrier housing

NOTICE

Use care to not allow any of the Loctite

compound to

get in the bearing.

8. Wipe the housing clean of any excess compound

and install the snap ring

9. Allow Loctite to cure for at least 3 hours before

vehicle operation.

FINAL DRIVE

Polaris RZR PRO XP 2021 User Manual

Questions and Answers: