12
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
12.11
2. Press either toggle button to cycle to the desired
“UNITS” option (distance, temperature or volume).
Press MODE to select.
3. Press either toggle button to cycle to the desired
setting.
4. Press MODE to save and exit to the settings menu.
TRIP METER
Use a trip meter to track the distance traveled during a
specific trip or period of time. Reset the meter to zero
before traveling.
1. Press either toggle button to cycle to the desired trip
meter option (T1 or T2).
2. Press and hold either toggle button until the meter
resets to zero.
TRIP TIME
Use a trip time meter to track the travel time during a
specific trip. Reset the meter to zero before traveling.
1. Press either toggle button to cycle to the trip time
option (TT).
2. Press and hold either toggle button until the meter
resets to zero.
PROGRAMMED SERVICE INTERVAL
The service interval counter is programmed to 25 hours
at the factory. As hours of engine operation increase, the
counter decreases. The wrench icon will flash for about
10 seconds when the counter reaches zero (0), and each
time the key is turned on thereafter, until the counter is
reset.
When this feature is enabled, it provides a convenient
reminder to perform routine maintenance. Refer to
“Periodic Maintenance Chart page ” for
recommended service intervals
Use the following procedure to reset or change the
service interval:
1. Press and hold the MODE button to enter the settings
menu.
2. Press either toggle button to cycle to the “Service
Hours” option. Press MODE to select.
3. Press MODE to reset the existing value and exit, or
press either toggle button to change the value. Press
MODE to save and exit to the settings menu.
RIDE COMMAND UNIT REPLACEMENT
REMOVAL
1. Remove two fasteners
q
and remove hood.
ELECTRICAL
To Next Page
Loading...
Need help?
General
