BODY / STEERING / SUSPENSION
5.7
A-ARM REPLACEMENT
1. Elevate and safely support vehicle with weight removed from front wheel(s).
2. Remove cotter pin from ball joint stud at wheel end of A-arm and loosen nut until it is flush with end of stud.
3. Using a soft face hammer, tap nut to loosenA-arm from bolt. Remove nut and A-arm from hub strut assembly.
4. Loosen two bolts on A-arm tube by alternating each about 1/3 of the way until A-arm can be removed.
5. Examine A-arm shaft. Replace if worn. Discard hardware.
6. Insert A-arm shaft into new A-arm.
7. install CV joint shields.
8. Install new A-arm assembly onto vehicle frame. Torque new bolts to 30 ft. lbs. (41.4 Nm).
WARNING
The locking features on the existing bolts were destroyed
during removal. DO NOT reuse old bolts. Serious injury
or death could result if fasteners come loose during
operation.
9. Attach A-arm to hub strut assembly. Tighten ball joint
nut to 25 ft. lbs. (35 Nm). If cotter pin holes are not
aligned, tighten nut slightly to align. Installanewcotter
pin with open ends toward rear of machine. Bendboth
ends in opposite directions around nut.
10. Locategrease fitting in center of A-arm tube andpump
A-arm full of grease.
WARNING
Upon A-arm installation completion, test vehicle at low speeds before putting into regular service.
Vehicle Frame
Nut
Cotter Pin
Ball Joint
Stud
CV Joint Shield
A-Arm Tube
A-Arm Shaft
Bolt 30 ft. lbs.
(41 Nm)
Washer
25 ft. lbs
(35 Nm).
8 ft. lbs.
(11 Nm)
Bolt 30 ft. lbs.
(41 Nm)
Apply Loctitet 242 to
the bolt threads.
242
242
A-arm Attaching Bolt Torque:
30 ft. lbs. (41 Nm)
Ball Joint Stud Nut Torque:
25 ft. lbs. (35 Nm)
Enfocus Software - Customer Support
To Next Page
Loading...
