TRANSMISSION
8.5
TRANSMISSION REMOVAL
All operations regarding transmission front output
housing assembly can be performed with
transmission installed in frame.
1. Remove the inner PVT cover. Refer to Clutch
Chapter.
2. Remove complete airbox assembly and
transmission vent line.
3. Loosen rear wheel nuts slightly.
4. Elevate and support machine under
footrest/frame area.
CAUTION: Serious injury may result if machine tips
or falls. Be sure machine is secure before beginning
this service procedure. Wear eye protection when
removing and installing bearings and seals.
5. Remove wheel nuts and wheels.
6. Disconnect transmission shift linkage rods.
Remove right hand shock absorber.
7. Disconnect harness from gear position switches.
8. Remove right rear drive shaft (see Chapter 7).
Pull outward to remove
from transmission
9. Disconnect the sway bar from both sides.
Remove right side upper control arm.
10. Remove left side shock absorber.
11. Remove left rear drive shaft (see Chapter 7).
12. Remove left side upper control arm.
13. Remove both lower transmission mounting bolts
from each side.
Lower Mounting Bolts
Enfocus Software - Customer Support
To Next Page
Loading...
