TRANSMISSION
8.2
TORQUE SPECIFICATIONS
COMPONENT FT. LBS.
(IN.LBS.)
NM
Transmission Case Bolts 12 16.6
Bell Crank Nut 12 16.6
Transmission Drain Plug 14 19
Transmission Mounting
Bolts
25 34.5
SPECIAL TOOLS
PART NUMBER TOOL
DESCRIPTION
2871701 (Part of 2871702 Kit) 2 1/8 inch Wrench
2871697 (Part of 2871702 Kit) Center Drive
Bushing Tool
2871695 (Part of 2871702 Kit) Backlash Setting
Tool
2871698 (Part of 2871702 Kit) Rear Output Seal
Driver
2871699 (Part of 2871702 Kit) Rear Driveshaft
Seal Guide
2871282 Bearing Seal
Driver (50 mm)
LUBRICATION
Refer to maintenance section for transmission
lubricant type and capacity.
GEAR SHIFT SELECTOR
REMOV
AL
NOTE: To change fluid, remove selector box
assembly, disassemble, clean, and assemble.
1. Remove parts that interfere with access to shift
selector (seat, right side panel, and exhaust heat
shield, etc.).
2. Disconnect the two linkage rods from gear shift
selector slides.
3. Remove five bolts attaching gear shift selector to
the mounting bracket.
4. Lift gear selector out of mounting bracket and
away from frame.
GEAR SHIFT SELECTOR
DISASSEMBL
Y
CAUTION:
Wear eye protection during this procedure. Read
each step completely before proceeding. Essential
parts may be lost or damaged if you do not heed this
caution!
1. Clamp gear selector body lightly in a soft jawed
vice. Using a cross pattern, loosen each of the
four screws holding the gear shift selector cover
to the gear shift selector body. Loosen each
screw only a few turns, then proceed to another
screw.
NOTE: These parts are under pressure from the
internal springs.
2. Carefully pull the gear shift selector cover and rod
from the gear shift selector body.
3. Set the cover/rod assembly aside.
Enfocus Software - Customer Support
To Next Page
Loading...
