TRANSMISSION
8.17
TRANSMISSION ASSEMBLY, CONT.
A
16. Make sure surface of access plate and
transmission are clean and free of oil and grease.
Apply Crankcase Sealant (PN 2871557) to
mating surface of transmission case. Install
access plate with notch to front as shown, torque
screws to specification.
Access Plate Screws:
8 - 10 ft. lbs. (11-14 Nm)
17. Using the Magnum crankshaft installation tool,
lubricate and carefully install the front seal until
flush with housing.
Enfocus Software - Customer Support
To Next Page
Loading...
