TRANSMISSION
8.7
5. Apply anti--seize to splines of rear drive shafts,
insert drive shafts into transmission. Install left
andright rear upper control arms. Installstabilizer
bar arm on stabilizer bar.
Apply anti--
seize
to splines
6. Install brake disc and washer with domed side
out, against nut.
7. Install caliper,auxiliary brake master cylinder, and
transmission shift linkage rods. Install left and
right hand shock absorbers.
8. Apply brake and torque disc nut to 45 ft. lbs. (61
Nm).
9. Install PVT system. Refer to PVT section for
procedure.
10. Install airbox assembly and transmission vent
line. Be sure vent line is not kinked or pinched.
11. Add Polaris Premium Synthetic Gearcase
Lubricant to the proper level on dipstick.
(Approximately 1 quart). Do not overfill.
Premium Synthetic Gear Case Lubricant
(PN 2871478) (12 oz.)
(PN 2871477) (Gallon)
12. Install the rear wheel nuts and torque to
specification.
Rear Wheel Retaining Bolt Torque
20 ft. lbs. (27 Nm)
13. Refer to Maintenance Section to adjust
transmission linkage.
Enfocus Software - Customer Support
To Next Page
Loading...
