Hull/ControlSystems
6.21
Decal Removal / Application
1. Clean the original decal and surface with mild
detergent or household cleaner.
2. Take the new decal and align it with the old decal.
Using a felt--tip marker, outline at three or more points,
the position of the new decal.
3. Use a heat gun to soften the adhesive of the old decal.
W ARNING: Use the heat gun on its lowest heat setting.
Do not heat the decal or hull for more than a second. Waiv-
ing the heat gun back and forth once is sufficient to soften
the adhesive. Prolonged heating will permanently damage
the hull.
To Next Page
Loading...
Need help?
General
