Maintenance
2.32
Hull/ControlSystems
Handlebars/Hand Grips
1. Pull and twist on hand grips to ensure they are not loose.
If loose or wore, the handlebar with grip assembly must
be replaced.
2. Check steering support hub fasteners and make sure
they are tight. Check handlebars and hub for cracks or
damage. Replace if cracked or damaged.
3. Inspect steering arm bolt torque.
Fasteners / Parts / Hoses
Inspect the watercraft for any loose nuts, bolts, fasteners
and hoses. Be sure that all hose clamps are tight. Replace
cracked, damaged, or deteriorating hoses.
Seat Adjustment
1. Remove seat and loosen lock nut on rear post.
2. T urn clockwise to provide more seal pressure and
counterclockwise to reduce pressure (if seat is too
tight or new seal installed).
3. Repeat steps one and two for center post.
4. Reinstall seat and make sure it latches securely with
no up and down movement at front or rear.
Handlebar w/grips
Fasteners
Steering Arm Bolt Torque
14 ft. lbs. (19.3 Nm)
To Next Page
Loading...
Need help?
General
