Electrical Systems
7.28
Ignition Tim ing Adjustment -- Ignition Point Adjustm ent Unit -- Continued
8. Connect timing to light to MAG high tension wire.
Start engine and verify timing with timing light.
CAUTION:
Never operate the engine for more than 15 seconds while
the watercraft is out of the water. Overheating of engine
and drive line components will result.
9. T iming can now be set to exact specification
using the Ignition Point Adjustment Unit. Press
the POS or NEG button to advance or retard
timing until timing is at specification. Pressing the
POS or NEG buttons will advance or retard the
timing in one degree increments up to two
degrees each way.
10. After correct timing has been established,
remove the timing light and install the timing
cover plug.
11. Remove exhaust and battery cable. Open
electrical box and disconnect the Ignition Point
Adjustment Unit. Reassemble the electrical box
and install.
12. Reconnect the battery and any exhaust hoses
that were removed to access the electrical box.
To Next Page
Loading...
Need help?
General
